How to change the Middle Light on Kalina. Troubleshooting Middle Lights in Lada Kalina

The procedure for removing and installing the headlight, which is located on the right or on the left side, is not particularly different from each other. It is important only to act clearly according to the instructions. When installing a new light bulb, it is necessary to keep it only for the base, it is impossible to touch the hands. When removing can be completely taken in hand.

Note that for the Lada Kalina (motor on 16 valves) requires a lamp with a base of H7. Set a new one as follows:

• Define on planting place So that the protrusion in the base coincided with the groove on the spotlight. It must be firmly fixed. Only then will understand that the ledge fell into the groove;
• press the lock to the lamp so that the center of the base is between the latch of the clamp;
• latch the lock before fastening;
• they attach both wires to the retainer and close the lid tightly.

After performing this procedure, you need to turn on the headlights in the near distance and check their work. If everything is fine, it means that the installation is performed correctly. Otherwise, you will have to drive the car in the car service and pay money for it. Purchase lamps follow only in special stores. Give preference to preferably known manufacturers and models with a guarantee. Osram H7 12V 55W headlights are very popular today for Lada Car Kalina Cross.

Friendly quite often. The reason for the need to keep it almost always included. A few years ago in Russia, the law ordered drivers to manage vehicle With close-up light or running lights. Because of this, LBS's life was significantly reduced, so each driver should know how to replace them. All about it - in our article.

[Hide]

Why doesn't the Middle Light burn?

The reasons for which you have stopped burning the Middle Light may be several:

• light bulb burned out;
• the problem is in contact blocking pads;
• overwhelmed light electric fuse.

Before starting repair work, you need to install what exactly the problem is. For this, a small study is carried out.

First, you need to check the headlight fuse that does not work. Please note that each headlight has its own separate fuse. In Kalina, these are fuses under the number F12 and F13.

Checking its performance is simple enough, any problems can be detected visually. If everything is in order with it, check the condition of the pad and the lamp itself. In order to check the condition of the pads and light bulbs, you will need to disassemble the Faro itself. How to do this, in this article will be told in the section "Guide to replace light bulbs in the near light".

What lamps are better installed in the headlights of the near light?

If you need a new light bulb, first you need to choose correctly. There are many such parts on the car market and easy to make a mistake.

For near light on Kalina, the H7 12V / 55W lamp is needed. The first two signs, H7 indicate the title type to choose. With him on the market today you can find many different light bulbs. It is recommended to choose products of famous companies, as it is usually more reliable. So, for viburnum you can find parts manufactured by Philips, Bosch, Osram and Chinese lighthouse, the cheapest of the options.

Guide to replace light bulbs in the Middle Light

The replacement process is quite simple and carried out in several basic steps.

1. First you need to open the hood. Under it, find the rubber boot of LBS and remove it.
2. Next, just remove the block and remove to the side.
3. The lamp is fixed with a spring retainer. You should just click on it, then slightly take to the side and then raise.
4. The next stage is to pull the old light bulb.
5. When dismantling is finished, it's time to install new detail. All installation is made in the reverse order indicated above.

As you can see, dismantling the old detail and the installation of the new can be very simple in just a few minutes. Having done this once, you can always repeat. Facilitates the task and easy access to the spotlight in Kalina (author of the video - channel car repair).

Features Replace Far Light Lamp

Although, as indicated above, LBS burns out much more often due to more work hours, in some cases it is necessary to replace and.

If you know how to replace LBS, then far Light CANCE. Steps In this process, the exact same: first remove the boot, then disconnect the block and so on. There are no special nuances here, since in Kalina, the headlights are arranged as simple as possible.

Question price

Video "Replacing Lamp BS"

This video features the entire process of replacement of parts (movie author - KalinaAutochannel)

It is good only that car that is fully working. Even if the car is the most expensive and rare model, it will not be completely no sense from it if it cannot work correctly. This is especially true. In this case, it is dangerous not only the driver himself, but all participants road. Look below, consider everything regarding the Middle Lights on the "Lada Kalina" - how to select them and correctly install.

Optics on Kalina

You should think about the change of the near light lamp on the "Lada Kalina" and in the event that it does not give the necessary amount of light. This circumstance can lead to a serious accident.

For some reason, it is considered that with most problems technical character Only a specialist for a hundred can cope in Lada Kalina. But as for the light bulb of the near light, then such a process is under the power of almost every car owner. The main thing is to correctly select the element failed and correctly install it (according to specifications).

Preparatory stage

Immediately it should be noted that it is very difficult to get to the headlight in Lada Kalina. Install the new light bulb to the touch is almost impossible.

So that the installation process is as simple as possible, it is necessary to remove everything more superfluous in the field of headlights. Please accept the replacement of the near light bulb on the "Lada Kalina" should be carried out only when the power is turned off. Otherwise, it may be unsafe. After graduating from all preparatory work You can start the process of replacing the lamp.

If you are not sure that you will correctly change the old ones on the new lamp for the Middle Light on the "Lada Kalina", better contact the specialists for a hundred.

Installation process

If you buy a lamp for bright light in the neighbor headlights of foreign production, you can simply follow the instructions. It all extremely clearly painted, so you will not be difficult to change the light bulb in the headlight.

After the light is with you, and the headlight is removed, it will be possible to start the installation process. Initially, you need to remove a special rubber casing. You can make it an ordinary screwdriver. So it will be easier to pry the edge of the rubber base. There is a casing from the inside of the headlight.

After removing the casing, you can begin to dismantle the old lamp for light. Originally removed terminals from the lamp. At this stage, it is important to remember their initial location. Next, you should remove special metal clamps that kept the old lamp of light. It is easy to remove it. It is possible to do this with almost no remedies.

Installing a new light bulb

Only then you can remove the old lighting device and start installing a new one. Please note that the old burnt lamps are subject to recycling.

Before you start screwing down a new device in a headlamp, you need to make sure that the integrity of the contacts and only after that insert a new light bulb.

Please note that in the process of screwing the new item, it is impossible to allow hands to touch the glass part. It is determined by the fact that so the lamp will be much faster (overrigent). If this happened, the glass part of the alcohol should be wider and wait for complete drying.

At the final stage it is important to correctly install the terminals, not confusing the polarity (plus and minus). After that, you can install a rubber case back and test the device.

Middle Light Bulb Connection

Required tools

A special set to replace the lighting device will not need in this case. All you need is a wrench of 8 on 10. It is due to the fact that the right headlight is closed by the washer tank cover. Especially should be neat with the Bach itself. To install the Middle Light lamps as safe as possible, it should be completely removed. It is necessary to do this very carefully so as not to pour the liquid.

Many motorists faced the fact that at a certain point ceased to burn the nearest light lamp in Lada Kalina. The causes of the combustion of the lamp can be the wear or accumulated condensate in the spotlight, which led to a closure. The replacement process is carried out quite easily and simply, which makes it possible to make this operation to each motorist.

On the video, the process of replacement and installation of a near-light lamp in the headlight to Lada Kalina:

The lamp replacement process lasts 5-10 minutes. Experienced motorists can handle two. The toolkit does not need any. We will proceed to the replacement process:

Thus, the lamp is replaced and the car is ready for further operation.

Lamp selection

H7 lamp type, do not confuse

Middle Light lamp marked - H7.

It is easy enough to find on automotive market Or in stores selling spare parts. The most common manufacturer remains OSRAM.

On the left of the Chinese lighthouse, on the right of the domestic domestic

These are the domestic lamp production, which were popular due to the ratio of the price-quality criterion.

Another good manufacturer are:

• Bosch,
• Hella
• Koito,
• Philips
• Valeo.

This is already higher quality lamps, which are higher than the nationwide OSRAM. Thus, the choice of lamps is quite wide, and every car owner will be able to choose.

Diode Lamps in Middle Light

Controversial question. It is difficult to choose the optimal quality.

conclusions

Replacing the Middle Light on Kalina is carried out quite easily and simply. The main thing is to choose a lamp that must Be marked H7. . The most common manufacturers who choose motorists is OSRAM and Philips.

How is the replacement of a near-light lamp on Lada Kalina

In the daytime, every car enthusiast hopes for day lighting, your eyesight and reaction. However, everything changes with the onset of darkness. At this time, you need to be particularly attentive, since it is often the accident on negligence when bad visibility. In order not to this, the front headlights must be working. If they do not work, it is impossible to carry out any movement. Even if you want, you will not come out, because visibility is zero. Thus, it is very important to ensure that the lanterns are clean and brightly shone.

How to replace the near light lamp Kalina with a body hatchback, sedan, wagon

Perform a replacement absolutely not difficult. For this you do not need to have special knowledge and skills. With such a task, even an inexperienced bus owner can cope. The only one must act consistently and clearly. So, the replacement of the lamp consists of the following steps:

This procedure ends. It is very important to remember how the lamp was located and which wires were connected to it.

Replacing the Middle Lamps. Lada Kalina.

Replacement middle Lamps Kalina. Independent replacement middle Lamps on the kalina. Board newcomer ...

Replacing Middle Lamps Kalina

Replacement middle Lamps H7. Lada Kalina.

Otherwise you can incorrectly connect new fairwhich is why you have to turn to the masters. If you feel that this work is not for you, it is better to immediately deliver the car into a technical service where all the procedures are fulfilled for you. Of course, it will have to pay for it, but the result will be the maximum.

Installing New: Serial Instruction

The procedure for removing and installing the headlight, which is located on the right or on the left side, is not particularly different from each other. It is important only to act clearly according to the instructions. When installing a new light bulb, it is necessary to keep it only for the base, it is impossible to touch the hands. When removing can be completely taken in hand.

Note that for the Lada Kalina (motor on 16 valves) requires a lamp with a base of H7. Set a new one as follows:

• Determine the landing place so that the protrusion in the base coincided with the groove on the spotlight. It must be firmly fixed. Only then will understand that the ledge fell into the groove;
• press the lock to the lamp so that the center of the base is between the latch of the clamp;
• latch the lock before fastening;
• they attach both wires to the retainer and close the lid tightly.

After performing this procedure, you need to turn on the headlights in the near distance and check their work. If everything is fine, it means that the installation is performed correctly. Otherwise, you will have to drive the car in the car service and pay money for it. Purchase lamps follow only in special stores. Give preference to preferably known manufacturers and models with a guarantee. Osram H7 12V 55W headlights are very popular today for Lada Car Kalina Cross.

Do not save and acquire low quality headlights because they will not last long and will require frequent adjustment or replacement. It is important to understand that not only your safety, but also pedestrians depends on these light bulbs. It is especially important that the lighting is high-quality at night in order to avoid tragic consequences.

On our site there is a special offer. You can get a free consultation of our corporate lawyer, just asking your question in the form below.