How to start a car if you got a battery

Winter frosts Motorists often presented a lot of unpleasant surprises. They are not even insured against troubles and those who constantly monitor the battery and regularly changes it. If the window is below -25 ° C, the fully effective battery will lose almost half of the containers in the flasks: the electrolyte becomes thick, the chemical system slows down and the battery is no longer able to give its energy.

Riding around the city with enabled heaters plant the battery, not to mention the fact that many drivers forget on the parking turn off the dimensions.

The fact that the battery is discharged will indicate the drag sober and the starter clicks when the driver tries to start the motor or fuzzy luminescence of the indicators.

But do not despair if the battery does not respond to anything. The output is from any position. The battery can be given in four ways.

How to run a motor, seizing the battery from the "donor"

This is the most universal way to revive the battery, it is not for nothing that it is so popular with motorists.

It is suitable for any type of transmission and for any car.

What is needed for this?

Machine donor with serviceable battery;

Starting wires with clips.

If the machine has stalled on a busy track, you can find a donor car. But what about the starting wires, then everything is more complicated here, for not many of them carry them in the trunk.

What to do?

So you successfully start the engine of the machine with a discharged battery and not harm your savior, the sequence of actions must be followed correctly:

1. Machines must be close to one to another;

2. The donor motor motor must be turned off;

3. Red-colored wire wire must be copped with the positive terminals of both acb;

4. One of the ends of the black wire must be connected to any car motor part, and the second to the minus terminal of the donor battery.

5. With a trial launch, you do not need to make a car more than 2-3 attempts.

6. Engine, if it starts, you need to give a "plug" a couple of minutes, and then in the reverse order of removing the wire terminals.

Do not try to see your car, if he has 2 l. The volume of the motor from the base, since the capacity of the acb donor should not be less than the revived car. Each of the devices must have an equal voltage.

How to start a car with a tug

You can run the engine the car if the battery is not fully sat down and the charging is enough for the fuel pump to get fuel from the gas tank into the system.

This method is good only for cars with MCPP.

What will be required for this

second car.

Since anything can happen on the road, the towing cable is always necessary to keep in the trunk.

What to do

Everything is trite and simply and does not require completely no special skills.

1. The cable must be picked up to the second car;

2. Rotate the ignition key on your car, squeeze the grip and switch to 3 speed, keeping the foot on the clutch pedal;

3. Let the driver of the towing machine so that he began to move;

4. After a small acceleration, let go of the clutch;

5. After the car begins to squeeze the grip again and snag the driver of another car.

It is not necessary to inlets to switch to neutral, the engine must work a little so that the oil in the transmission warms out.

How to get a car rope

This is a way quite complicated, but it can help.

You can use it only on a car with "mechanics".

What is needed for this

And the jack and rope can be found in almost every car.

What to do

1. Put the car to the "handbrake", and under the wheels to put the stops.

2. The jack is needed to lift cars so that the leading wheel is hung in the air.

3. Then you need to turn the ignition key and switch to the third gear.

4. Then you need to wind the rope and sharply pull.

5. If the car does not start from the first time, then everything must be repeated.

6. After the motor earn needs to turn on the neutral and lower the car.